Where We Run · 60647
Logan Square
Gut-rehabbed greystones and two-flats along the boulevards, most of them fitted with a professional range that went in during the remodel and has been cooked on hard ever since.
What a visit here usually involves
Ranges here were specified during a remodel and then cooked on properly, so the parts that come up are wear items rather than failures: electrodes, valve stems, hinge springs, oven sensors. Those ride on the van. What gets checked first on this stretch is manifold pressure, because a lot of these rehabs put a large appliance on a gas run that predates it.
- Appliances on this run
- 36" and 48" dual-fuel ranges, most fitted during a gut rehab
- Access
- Boulevard two-flats and greystones — usually a straight run from the kerb
- Booking
- 8:00 am – 8:00 pm, seven days. Dispatch answered 24/7.
What we are called out for
- Range Repair Dual-fuel and all-gas professional ranges taken as one appliance rather than two: burner and griddle behaviour on the top, ignition and gas pressure underneath, and the oven cavity below it all diagnosed on the same visit.
- Oven Repair Built-in wall ovens and the oven half of a range — calibration drift measured against a probe rather than the display, convection faults, door and hinge work, and control boards that have locked themselves out.
- Cooktop & Rangetop Repair Sealed-burner rangetops, gas cooktops and induction tops — spark modules, burner heads and orifices, valve stems that have gone stiff, and glass tops where a zone has stopped responding.
- Range Hood Repair Professional hoods, liners and inserts — blower motors and speed controls, baffle and duct restriction, lighting circuits, and the make-up air problems that show up in a tight rehabbed kitchen long before the hood itself is at fault.
Also on this loop: Wicker Park, North Center, Portage Park.
What people say afterwards
4.9 out of 5 · 1668 reviews
The French top had cold patches towards the edge and would not come up in a sensible time. He found the burner beneath sitting out of true and reseated it, then verified the spread with a probe.
Coralie B. · Logan Square
A burner that ticked forever and only caught if you held the knob at exactly the wrong angle. Electrode had cracked at the ceramic. He carried a replacement and it lights instantly now.
Halina J. · Logan Square
A grinding noise from the back whenever convection ran. Fan bearing had failed. He replaced the motor and while he was in there cleaned out years of debris that had been feeding the wear.
Marguerita V. · Logan Square
One position lit and then died the second the knob came back. Thermocouple, replaced, and he checked the flame sensing on the rest of them before he would call the visit finished.
Juniper A. · Logan Square
Griddle was hot at one end and lukewarm at the other, so nothing cooked evenly. Sensor had drifted and the plate was sitting on a warped support. He corrected both and checked it with a probe.
Renata O. · Logan Square
The duct run goes up through the roof of a two-flat and the damper had stuck shut. He got up there, freed and replaced it, and the difference in draw was obvious the same evening.
Adelina G. · Logan Square
Booking a visit in Logan Square
Give dispatch the model off the frame, the fault and the address. You get a window that can be kept, and a firm price once the readings are taken.
$89 service call, credited against the repair · On site 8:00 am – 8:00 pm, seven days
